DCC for My Model Railroad

A couple of weeks ago (maybe 3) I got my DCC system. It's made by NCE and is their base radio system (PH Pro 5 Radio). I got it barely used and got a great deal on it. I also got an additional throttle.

First off, it's great. It has so much potential.

I got off to an interesting start. The problem with DCC is that you can't really run a train on it unless the locomotive has a decoder board installed. My locos did not have them. I knew about this, so the day before I was to receive my system, I took my locos to the train store to get decoders for them. The week before I had even ordered a decoder (with sound!). Two of my locos are old. 12 years or so. Back then DCC was out but not so common. There was a possibility that my locos would pull too much current for a decoder. So, I needed them tested and checked out before they got installed. The folks at the store took my three locos after I described what I wanted for each and then found out that they wouldn't be ready for at least a week. Ouch.

The next day, my wonderful new DCC system arrived. I got it all plugged in and ready to go. Wow, it looked cool. And that was it. That was all I could do. I could just look at it. I read through the manual. I guessed how awesome it would be and I waited.

As it turns out, decoder installation isn't completely easy. The guy installing ran into difficulties. At the sight of my obvious disappointment (which involved some whining), he offered to loan me some of his locos in the interim. So I borrowed two.
They were a pair of Atlas Master series locos. One had sound and one didn't. The sound was very cool. I played with that for a bit. The locomotive seemed to have hardly been used.

I would like to take a moment to point out that it ran very smooth. This was my first hands-on experience with a not cheap locomotive. It ran so quietly! I am not going to settle for less any more. When I got my locos back, it just drove that point home. The cheaper locos grind and they take a bit of throttle just to get started.

So, now I have it. A full 5-amp DCC system with two locos and a medium-sized oval... Total overkill, but I hope to remedy that in the not-to-distant future.

BTW, one loco is still in the shop. An old Atlas switcher. Probably the best loco I own (which has never really been used since I got it. Long story for later). However, it doesn't fit an HO decoder and so we need to find an N decoder that can handle HO current.